coor
¶
Node coordinate data. These data are usually created by a mesh generation program, then cut and copied into the input file or a separate geometry data input file. The mesh must be a right handed coordinate system. Note that X, Y, and Z coordinates must be entered even if a problem is not three-dimensional. Version2.30 added the ability to provide the coordinate data in a formatted or unformatted file.
Note
coor
is required if macro fdm
is not used.
- Group 1 - N
- Group 2 - MB, CORD1, CORD2, CORD3
To end the control section a blank line is entered.
Input Variable | Format | Description |
---|---|---|
N | integer | Number of nodes in the grid |
MB | integer | Node number. If MB < 0 then the difference between the absolute value of MB and the previously read absolute value of MB is used to generate intermediate values by interpolation. |
CORD1 | real | X-coordinate of node MB (m). |
CORD2 | real | Y-coordinate of node MB (m). |
CORD3 | real | Z-coordinate of node MB (m). |
The following is an example of coor
. In this example, there are 140 nodes in the grid. Node number 1 has X, Y, Z coordinates of 0., 200., and 0. meters respectively, node 2 has X, Y, Z coordinates of 12.5, 200., and 0. meters respectively, and so forth, with node number 140 having X, Y, Z coordinates of 300., 0., and 0. meters respectively.
coor | |||
140 | 0.00000 | 200.00000 | 0.00000 |
1 | 12.50000 | 200.00000 | 0.00000 |
. | . | . | . |
. | . | . | . |
. | . | . | . |
10 | 212.50000 | 200.00000 | 0.00000 |
. | . | . | . |
. | . | . | . |
. | . | . | . |
140 | 300.00000 | 0.00000 | 0.00000 |
© Copyright 2018, Los Alamos National Laboratory